Marked leak spot
Exact location marked on floor or wall
When your water bill jumps or your floor stays warm, leak detection Spring TX finds the source before it damages your foundation. We serve homeowners across Harris County with electronic and acoustic locating tools, then repair the line we find. One call gets a technician to your door, usually the same day.
Every leak call includes a full system check, locating work, and a clear explanation of what we found. Repair is quoted separately so you can decide before we cut anything. Here is what you get on a standard visit.


We find leaks under slabs, behind walls, and in yards for Spring homeowners. You get the spot marked and a clear price before any repair starts.
We locate leaks in commercial buildings, restaurants, and rental properties across Spring. Work is scheduled around your hours so you stay open.
Leak detection Spring TX is the process of locating water escaping from your plumbing system without tearing up your home to find it. We pressurize the line, then listen for the leak with acoustic microphones and trace it with electronic locators. A slab leak under your foundation, a pinhole in a copper pipe behind a wall, or a cracked fitting under the slab all show up on our equipment. Once we mark the spot, we know exactly where to cut and repair.
Spring homes sit on clay soil that shifts with every wet and dry cycle, and that movement stresses buried pipes until they crack. Most calls we run start with a high water bill leak detection Spring Texas request after a homeowner notices the meter spinning with every fixture off. If you have been searching for leak detection Spring TX near me, we cover the whole area and can usually be at your door the same day you call.
We find the leak, mark it, and fix it before we leave.
Five steps from the first phone call to a tested, dry line. You know what is happening at every stage.

Listens for the sound of water escaping a pressurized line. We run it along the floor and walls to narrow the leak to a small area before we mark it.

Traces the path of a buried or slab-embedded pipe so we know exactly where the line runs. This is how we avoid cutting in the wrong spot.

Inspects drain and sewer lines for cracks, root intrusion, and offset joints. We use it when a leak is on the drain side rather than the supply side.

Makes clean, code-correct connections on copper and PEX without an open flame. Faster than soldering and safer inside a wall cavity.

Cuts copper cleanly and solders new fittings when a press connection is not the right fit. Standard tools on every repair truck.

Shows temperature differences on a floor or wall. A hot water slab leak shows up as a warm band that traces the pipe route.

We shut off fixtures and pressurize the system in sections to confirm there is a leak and narrow it to one line. This is the first step on every call and it takes about 20 minutes.

We place a microphone on the floor or wall and listen for the leak sound. Water escaping a pressurized line makes a distinct hiss that gets louder as we get closer to the break.
We run a full pressure test and locate the leak with electronic tools. Most high-bill calls turn out to be a slab leak, a running toilet, or an irrigation line break. You get the leak found and fixed, and your next bill drops back to normal.
We run a pre-purchase leak check with acoustic and electronic equipment. We confirm whether there is an active leak and mark it if there is. You know what you are buying and can negotiate the repair into the deal.
We run pool leak detection Spring TX 77379 calls with pressure testing on the pool line and dye testing at the fittings. We find the break and mark it for repair. The pool stops losing water, the pump runs normal cycles, and you stop topping off the pool every week.
We pressure-test the line and use acoustic microphones to pinpoint the split. Then we cut a small access and replace the damaged section with PEX or copper. The wall stays closed except for one small patch, and the line holds pressure.
Spring sits on expansive clay soil that swells when it is wet and shrinks when it dries. That movement stresses buried copper and PVC lines until they crack, which is why slab leak detection Spring TX calls spike after a dry summer. Most homes here were built between the 1970s and the 2000s, so we work on a mix of copper, CPVC, and PEX. Copper from the 1980s is often thinned by years of slightly aggressive water and fails at fittings. Newer PEX builds in Harmony and Spring Trails rarely leak at the pipe but can leak at a crimp ring or manifold connection. Summer heat pushes supply lines to 120 degrees or more in an attic, and winter freezes crack lines that were already stressed. We adjust our locating approach based on the pipe material and the season. If you have been looking for water leak detection Spring Texas service that knows the difference, that is what we do.
A homeowner in Ponderosa Forest saw her water bill jump from $95 to $260 in two months. The meter spun with every fixture off. Two other companies told her she needed a full repipe without locating the leak.
We pressure-tested the system, located a hot water slab leak under the hallway, and marked it. One 12-by-12 access point, one copper repair, and a pressure test. Her next bill was $88.
We recommended a pressure check every 18 months and a water softener to slow copper corrosion. She has had no further leaks in three years.
A yard in Gleannloch Farms had a wet spot that never dried and a ring of dead grass. The irrigation system was ruled out. The homeowner was losing about 150 gallons a day.
We traced the main supply line with an electronic locator and found a cracked PVC fitting two feet from the foundation. One hole, one repair, and the yard dried out in a week.
We marked the repaired line on a yard map and suggested a yearly meter check in Spring. No repeat leak since.
A pool in the 77379 area was losing an inch of water a day. The pump ran longer cycles and the homeowner was topping off the pool twice a week. Two pool companies had found nothing.
We pressure-tested the pool line, dye-tested the fittings, and found a crack at a return line elbow. We repaired it and the pool held level through the next month.
We suggested checking the pool level weekly and marking the normal evaporation rate. The homeowner now knows what a real leak looks like.
Most leaks do not announce themselves. They show up as a higher bill, a warm floor, or a damp spot that keeps coming back. Here are the calls we run most often in Spring.

We pressure-test the system, isolate the supply from the drain, and locate the leak with acoustic and electronic tools. You get the spot marked and a repair price the same day. A hidden leak can waste 200 gallons a day or more, adding $80 to $200 a month to your bill and softening the soil under your foundation.

We map the hot water line, listen for the break, and confirm the location before cutting. Most slab repairs need one small access point, not a trench across the room. A hot water slab leak heats the floor above it and can crack tile or shift the slab if it runs for weeks.

We use underground leak detection Spring TX equipment to trace the line and mark the break. Then we dig one hole at the mark, repair the pipe, and backfill. An underground leak wastes water, kills grass in a ring, and can undermine a driveway or walkway over time.

We isolate sections of the system to narrow the leak to one line, then locate it. You get a clear finding and a repair plan in one visit. This confirms a supply-side leak somewhere in the system. Ignoring it runs up the bill and risks a burst pipe behind a wall.
A slab leak can add $80 to $200 a month to your bill before you notice. We locate the break, stop the loss, and you see the difference on the next statement.
Water under a slab softens the soil and shifts the foundation. Catching a water leak under foundation Spring TX early prevents cracks in walls, sticking doors, and repair bills in the thousands.
We mark the exact spot before anyone cuts concrete or opens a wall. That means one small access point instead of a row of holes across your floor.
Most leak calls get a technician on site the same day. You get a clear finding, a repair plan, and a price before we start work.
Typical 2026 pricing for leak detection in Spring runs $180 to $450 for the locating visit, depending on whether we are checking a slab, a wall, or an underground line. If you approve the repair, we credit part of the detection fee toward the fix. We give you the price before we start, and we do not add charges after the fact. The goal is to find the leak fast and keep the repair small.
What your estimate is based on
$180 - $450 for detection; repairs quoted separately The detection fee is small compared to the damage a hidden leak causes. One slab leak left for a month can shift a foundation and cost thousands. Finding it early is the cheapest repair you will make this year.
Clear records you can keep and share.
Exact location marked on floor or wall
Short summary of what failed and where
Clear quote before any work begins
A high water bill is the most common sign of a hidden leak. The meter test takes two minutes and tells you whether to call.
Turn off every fixture and watch the meter dial. If it moves, you have a supply-side leak. If it stays still, the leak is on the drain side.
A warm spot on the floor usually means a hot water slab leak. The heat follows the pipe route, so the spot is often not directly above the break.
A damp spot that never dries points to an underground line leak. It can be the main supply, an irrigation line, or a pool line.

Not on the list? Call and ask if we can get to you. +1 (831) 293-1204
Most leak detection calls in Spring run $180 to $450, and the visit takes two to four hours. The price depends on whether we are checking a slab, a wall, or an underground line. If we find the leak and you approve the repair, we credit part of the detection fee toward the fix. You get the price before we start.
The clearest sign is a water bill that jumps 20% or more with no change in use. You may also hear water running when every fixture is off, feel a warm spot on the floor, or see cracks appear in tile or drywall. If you see any of those, call us for slab leak detection and repair Spring TX before the soil under your foundation shifts further.
Yes. We use acoustic microphones and electronic locators to hear and trace the leak from above the slab. We mark the spot on the floor, confirm it with a second pass, and only then cut a small access point. Most slab repairs need a single 12-by-12-inch opening, not a trench across the room.
A hidden leak is the most common cause. A running toilet flapper can waste 200 gallons a day, and a slab leak can lose far more. Check your meter with every fixture off. If the dial still moves, you have a leak. Call us for high water bill leak detection Spring Texas and we will find it the same day.
If your meter is spinning or your bill jumped, the leak is not going to fix itself. Call us and we will find it, mark it, and give you a price before we start. Same-day service across Spring and Harris County.
Call us at +1 (831) 293-1204 or email plumbersspringtx@gmail.com. We answer calls 24/7 for emergencies. For standard service, we schedule visits Monday through Friday from 8:00 AM to 6:00 PM. If you leave a message after hours, we will call you back first thing the next morning.